blob: 948588d46c627a30251d369b9810e3935dccda7f (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
|
.. _module-pw_sys_io_emcraft_sf2:
---------------------
pw_sys_io_emcraft_sf2
---------------------
``pw_sys_io_emcraft_sf2`` implements the ``pw_sys_io`` facade over
UART.
The Emcraft SF2 sys IO backend provides a UART driver layer that allows
applications built against the ``pw_sys_io`` interface to run on a
SmartFusion/2 chip and do simple input/output via UART. However, this should
work with all Smartfusion/2 variations.
This backend allows you to configure which UART to use. The point of it is to
provide bare-minimum platform code needed to do UART reads/writes.
Setup
=====
This module requires relatively minimal setup:
1. Write code against the ``pw_sys_io`` facade.
2. Specify the ``dir_pw_sys_io_backend`` GN global variable to point to this
backend.
3. pw_sys_io_Init() provided by this module needs to be called in early boot
to get pw_sys_io into a working state.
4. Build an executable with a main() function using a toolchain that
supports Cortex-M3.
.. note::
This module provides early firmware init, so it will conflict with other
modules that do any early device init.
Module usage
============
After building an executable that utilizes this backend, flash the
produced .elf binary to the development board. Then, using a serial
communication terminal like minicom/screen (Linux/Mac) or TeraTerm (Windows),
connect to the device at a baud rate of 57600 (8N1).
Dependencies
============
- :ref:`module-pw_sys_io`
- :ref:`module-pw_preprocessor`
|
