1 files changed, 38 insertions, 0 deletions
diff --git a/hardware/fab/shield/README.txt b/hardware/fab/shield/README.txt
new file mode 100644
index 0000000..b62c209
--- /dev/null
+++ b/hardware/fab/shield/README.txt
@@ -0,0 +1,38 @@
+ASHIELD Board, v2.2
+3/25/2011
+
+Route board out on 0-mil perimeter in top silk.
+
+Standard .062" FR4, 1oz Cu, RoHS, HASL
+
+Board is 2 layers, plus unusual silk screen (see notes below)
+
+!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
+NOTE: VENDOR MARK AND TEST STAMP SHOULD BE PLACED WITHIN JOY1 RECTANGLE.
+      MARK AND STAMP MUST NOT BE VISIBLE ONCE BOARD IS ASSEMBLED.
+!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
+
+Other Notes:
+
+Board is WHITE SMOBC
+
+ashield_blk.plc         BLACK primary (first applied) silk, component side
+                        This is a base silk.  Colored silks go on top of this one.
+
+ashield_blk.pls         BLACK silk for bottom (solder) side of board
+
+ashield.drl             Drill rack
+ashield.drd             Excellon drill file
+
+ashield.cmp             Component side copper
+ashield.stc             Component side stop mask
+
+ashield.sol             Solder side copper
+ashield.sts             Solder side stop mask
+
+All components on TOP side of board, EXCEPT for 6 single-row in-line headers
+on left and right edges.  There is 1 6-pin header and 5 8-pin headers.  These
+mount from the bottom, and are soldered from the top.
+
+Through-hole leads should be trimmed flush.
+